AV2 + AVA7 + BASS EQ BUNDLE 

 AVA7
With 7 x 125 watts of power, the AVA7 delivers superb sonic performance and interfaces directly with the AV1, enabling superior remote control. It's also vented from the rear and the sides, rather than from the top, for direct stacking above or below the AV1.

AV
Digital Audio/Video Processor and 7.1 Channel Preamp

SPECIFICATIONS


  HDMI™ Performance 
HDMI™ Output Video: 480i/p, 576i/p, 720p or 1080i Audio: Dolby Digital, DTS and PCM (32, 44.1, 48, 88.2, 96, 176.4 and 192kHz)
HDMI™ Inputs Video: 480i/p, 576i/p, 720p or 1080i Audio: Dolby Digital, DTS and PCM (32, 44.1, 48, 88.2, 96, 176.4 and 192kHz)
Audio Input & Output Connectors 
Analog Audio Inputs One 8-channel input array, RCA connectors Six stereo RCA connectors One microphone, 3.5mm mono mini plug 1 dock 30-pin connector (for optional docking station)
Digital Audio Inputs Four S/PDIF coaxial (RCA) and four S/PDIF optical (Toslink) connectors (coaxial and optical input connectors conform to IEC-956, S/PDIF standards) One USB mini-B connector
Main Zone Audio Outputs One 8-channel pre-amplifier plus additional subwoofer, RCA connectors
Zone 2 Audio Outputs One RCA stereo connector
iPod Compatibility Audio only supported for all iPod "docking connector" models, including third-generation and later Click Wheel iPods, iPod photo (audio playback only), iPod mini and iPod nano. Not compatible with iPod shuffle™. iPod not included.
Audio Processing Section 
A/D Conversion 24-Bit, 96kHz, dual-bit architecture
D/A Conversion 24-Bit, 44.1kHz to 192kHz, multi-bit architecture
Frequency Response 10Hz to 40kHz, +0, -2dB
THD + Noise <0.05%, 20Hz to 20kHz
Dynamic Range 100dB typical, 22kHz bandwidth
S/N Ratio 100dB typical, 200kHz bandwidth, min 100dBA, 103dBA typical
Input Sensitivity 200mV for analog 1 to 6, and 200mV for 8-ch input Max input level: 2Vrms
Output Level 200mV typical, 6Vrms maximum
Video Input & Output Connectors 
Video Inputs 2 HDMI Type A, 19-pin connectors
Three component video, RCA connectors
Four S-Video connectors
Four composite video, RCA connectors
Video Outputs One HDMI Type A, 19-pin connector 
One component video, RCA connector
One S-Video connector
One composite video, RCA connector 
Composite & S-video Performance 
Compatibility NTSC, PAL and SECAM
Impedance 1V peak-to-peak/75Ω
Bandwidth Composite: 10Hz to 100MHz, -3dB
S-Video: 10Hz to 8MHz, -3dB
Component Video Performance 
Compatibility 3-Channel (Y/Pr/Pb), format-independent
Impedance 75 Ohms
Insertion Loss <3dB
Bandwidth >100MHz
General 
Trigger Outputs Two triggers - one power on/off and one programmable, 3.5mm mono mini plugs, 12VDC, 300mA maximum output draw
RS-232 Serial Input/Output One RS-232, 9-pin, D-sub connector 
Power Requirements 90-250VAC, 50-60Hz, 50W (universal line input), IEC detachable power cords (supplied)
Rack Mounting Rack-mountable chassis when used with Middle Atlantic RSH Series rack mounts.
Dimensions (H x W x D) Height (with feet): 5.0 inches (127mm) Height (without feet): 4.3 inches (109mm) Width: 16.8 inches (426mm) Depth: 16.7 inches (423mm) (includes knobs, buttons and terminals)
Weight Net weight: 17.6lb (8kg) Gross weight: 26.5lb (12kg)
Power Consumption 3.76W at power on, idle, 47.2W at rated power output (HDMI in/out mode)
Remote Control Hand-held, back-lit, IR/RF pre-programmed and learning remote control (requires 4 AAA batteries - included)